How to choose the thickness of nickel sheet for battery pack

How to choose a nickel strip for a lithium battery?

The width and material of the nickel strip should be selected according to the current of the lithium battery pack. In terms of material, there are two commonly used nickel strips: pure nickel strips and nickel plated steel. What is the difference between their performance and actual use?

How thick should nickel strips be?

I'm trying to minimize the thickness of my nickel strips, by evaluating how wide I can make my strips. Typical cheap spot welders have difficulty spot welding strips thicker than 0.15 mm. The largest cross sectional area on this chart is 12 mm wide and 0.15 mm thick, with optimal current carrying capacity of 17 A (from that table).

How many amps per square mm of nickel?

From what I've read and been told, 6.5 amps per square MM of Nickel is about the limit of acceptable for battery strips between cells. ideal would be less. As you can see, that works out to just about 1 amp per mm of width with .15 strips. Here's a couple of calculators. Buy the ticket, take the ride. You must log in or register to reply here.

What if each battery has a 15A nickel strip?

If each battery cell in parallel had its own 15A nickel strip connection to the next battery in series, you'd have 5 independent 12v batteries that arerated for 15A and are properly sized, adding a strip between them allows them to compensate for minor differences in voltage and capacity while also naturally balancing the 5 12v batteries together.

Should I use a nickel battery pack?

So, these are only recommended for low-current operations. When you are building a battery-powered low-voltage system, it's critical to build the battery with the right size nickel. It’s important to not overlook the wiring outside of the battery pack, as it’s just as important as the battery’s internal connections.

How much current can a nickel strip withstand?

For nickel-plated steel, its calculation formula is usually calculated according to 7A/mm², that is to say, the maximum continuous overcurrent of nickel-plated steel with a thickness of 0.15mm*7mm is 7*0.15*7=7.35A. It can be seen that the current that a pure nickel strip can withstand is about 1.5 times that of nickel plated steel.